Life Pixel – Canon 5D mk2 DIY Digital Infrared Conversion Tutorial

Disclaimer: This tutorial is intended for experienced professionals and made available to you for informational purposes only. Tampering with your camera will void your manufacturer’s warranty. If you decide to perform the conversion you could damage your camera or be hurt or get killed from the high voltage present – you do so at your own risk, we are not responsible for camera damage or any harm you may suffer or any special or consequential damages. Also, by visiting this site you are legally bound by our Terms of Use Agreement, we highly recommend you read it.

Focus Warning:  Because of the complexity and requirement for specialized precision equipment, advanced training and experience, we do not provide any information regarding focus calibration whatsoever.

The mere act of removing the sensor from within the camera could potentially ruin the original factory calibration and render your camera completely incapable of achieving proper focus. If this happens we will be unable to help you and even the manufacturer may refuse to service your camera. This is very serious stuff folks.

Focus and dust are in fact the most difficult parts of the conversion process. We highly recommend you send your camera in for conversion instead of attempting to do this yourself.

---

You will need these tools & supplies to follow the Canon 5D mk2 infrared conversion tutorial:

– Infrared filter to replace the hot mirror
– Small philips type screwdriver
– Tweezers
– Canned air
– Lens cleaning solution & tissue
– Grounding strap /w current limit resistor

If you prefer not to risk damage to your camera, have us convert it to infrared for you here. It would be best to perform the conversion in a well lit area that is as clean and dust free as possible. Wearing a grounding strap will minimize the chance of zapping your camera with static and most likely rendering it dead.

Remove the rubber grip material.

Remove marked screws.

Remove marked screw.

Remove the battery & holder.

Peel back the grip material and remove marked screws.

Remove the connector cap and marked screws.

Gently lift up the rear cover and disconnect marked cables.

Disconnect marked cables.

Disconnect marked cables.

Remove the I/O cover.

Remove marked screws and gently flip over the PCB.

Remove marked screws and gently flip over the sensor unit.

Disconnect the marked cable.

Remove marked screws.

Remove filter retainer.

Remove dust reduction filter.

Remove filter frame.

Gently remove the infrared blocking filter and separate from the filter gasket.

Install the filter gasket into the filter frame.

Place the filter frame back onto the sensor unit.

Place our infrared replacement filter onto the filter frame and follow the tutorial in reverse order starting with step 15 to reassemble your camera.